New Features

• Updated FW for compliance to the new regulatory EN 300 328 and EN 301 893.  

Known issue

• IPv6 Pass through mode doesn't work.

To Upgrade

Note: To avoid wireless disconnect issue during the firmware download process, NETGEAR recommends that firmware upgrade be performed on a computer with wired connection.

1. Using the Download Link below, download and extract the new firmware to a convenient place such as your desktop. The filename after extracting is DGND3800-V3.0.0.16_3.0.16.chk
   
   Download Link: http://www.downloads.netgear.com/files/GDC/DGND3800B/DGND3800B-V3.0.0.16_3.0.16.zip
   
   
2. Using a web browser, login to the router as admin.
3. Under Maintenance click Router Upgrade.
4. Click Browse and locate the upgrade file DGND3800B-V3.0.0.16_3.0.16.chk
5. Click Upload.
6. Wait for the upgrade progress bar to complete and final prompt to appear.
   If problems occur after upgrading, try clearing the configuration by pressing the Factory Defaults pushbutton on the rear panel until the Power LED blinks (about 10 seconds). Then re-enter your configuration information manually.

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.